The control environment is a nasty place, that’s why the Joral ProxEncoder is totally encapsulated in epoxy. With an IP69k configuration that survives destructive conditions like submersion in hydraulic oil, deep sea salt water, dust control spray, or corrosive wash.
MULTIPLE OPTIONS AVAILABLE
WHAT IS A PROXENCODER® NON-CONTACT SENSOR?
ProxEncoder Sensors are devices used for detecting rotation – in the form factor of a sensor traditionally used for linear measurement. As a Prox Switch made detecting linear motion simple – a ProxEncoder Non-Contact Sensor makes sensing rotation simple.
PE18 – 18mm Round
PEBX – Face Sense Rectangle
PEBX-101 – Side Sense Rectangle
Quadrature 64 standard PPR with index single ended push-pull driver
Analog 0-90, 0-180, 0-360 .5-4.5 VDC and 4-20 mA
PWM Output Voltage and Current
SAE J1939 with CAN Driver 8 sensors on a network
CAN with Can Driver 8 Sensors on a network
RS485 Modbus 32 sensors on a network soft address
SSI via 485 driver
ProxEncoder ® MOUNTING STYLES
The classic cylinder mount is quick and easy to install and adjust. Industry standard mounting brackets for 18mm prox switches are available from Joral and a host of prox switch vendors.
PEBX – 101
Square Side Sense allows the ProxEncoder to be installed on a flat surface, with minimum depth off the end of the monitored shaft. 2 #10 cap screws retain the sensor to the mounting surface.
Square End Sense allows ProxEncoder to be installed on a flat surface – with axial sensor placement to the monitored shaft. 2 #10 cap screws retain the sensor to the mounting surface.